In this article we’re going to look at how to make your own dog mask. We’ll cover the basics and then go on to look at some of the more advanced tips and tricks that you can use.

For those who have a dog that likes to bark, and especially if your dog loves to play in the backyard and other regions of the house, you need to get them some special dog protection.

Paper Plate 3d Dog Mask DIY Materials: This is the initial part of the set-up which will look a little scary at first, but it is actually quite straightforward. All you’ve got to do is take a cardboard cutting board and cut the cardboard into the shape of your mask. You can not just cut a rectangular shape from the cardboard, so you will have to cut around the edge of the mask so that you get something which looks like a cone. The most important thing here is to be realistic with what type of paper plate which you’re using.

Then you will need to wrap the cardboard around the edges of the paper plate, making sure there is a good seal between the two pieces so you can ensure that nothing will leak once you place the mask on. Make sure that the edges are cut so the edges are not sharp, as this can damage the edges of the mask.

Glue it on! The next step involves using some paint. You should spray the paint over the cardboard, making certain it runs smoothly and evenly across the whole mask. You’ll want to start with one side of the mask , so you can work your way round it before moving onto the other side. The paint has to be slightly thicker than the cardboard, and it’s best that you leave about one-third of an inch of paint on the edges so that it runs across the cardboard.

Don’t fret too much about the paint getting stuck to your mask. It’s easy to eliminate it later, and it’ll leave you with a wonderful finished mask to show off to everyone! It’s also a good idea to wash away any excess paint after you’re done, so you don’t end up with smudges or smears on your dog.

Then it is time to paste the mask onto your dog’s head. First you need to make sure that you get a secure fit between the mask and your dog’s head. Once you’ve made sure that it is secure, then you may begin to glue the mask on the dog’s face. Take the piece of cardboard that’s used for the base of the mask and then fold it over. Make sure that it’s quite strong and then use your hands to secure the cardboard down in place.

Keep your hands out of the way and use tape to hold it in place as you repeat the procedure on the cardboard folds until you have the mask snugged securely onto the face of your dog. Don’t make the folds too big or else it could look messy. Once you’ve done this, you can then take out the mask and then attach the cardboard ears. And attach the other part of the mask on the dog. Make certain the ears are level and be sure that it’s not too short or long as this will cause dog respirator mask some issues with the mask slipping off the dog’s face.

If you are using a dog mask as your pet security, you’ll need to do some sanding to be certain it’s safe on your dog. You can accomplish it by sanding off any excess paper which might have been removed from your mask.